TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2018-12-23 01:00:57

david.paige
Member
Registered: 2018-12-23
Posts: 1

After installation, what do I do now?

I installed TunSafe in Fedora.  I needed to install clang 7 instead of 6, and I had to change the build_linux.sh to reflect that, but otherwise it compiled, and appears to be running correctly.

But, what do I do now?  How do I connect?  When I check my IP address online, it shows my local ISP-provided address.  I don't see anything in my connections menu, so I'm not sure where to go from here.

Thank you.

Offline

#2 2018-12-23 22:31:27

logcabin
Member
Registered: 2018-04-30
Posts: 12

Re: After installation, what do I do now?

When I use the command "sudo tunsafe show" on Debian, I get this:

interface: tun0
  public key: E3Pxi2x/yhygoENhW94fKiErqqnSk5TcocjQw2g17A4=
  private key: (hidden)
  address: 10.188.99.19/8

peer: FO1Hc6UeM0lG8fSxSZYm/ED/4hfTsJ3VcnM09uDtjzM=
  endpoint: 38.132.98.4:27440
  allowed ips: 0.0.0.0/0
  latest handshake: 2 seconds ago
  transfer: 2.06 GiB received, 145.58 MiB sent
  persistent keepalive: every 25 seconds


Your output should be similar, except for the port number.

Offline

#3 2018-12-24 12:56:11

ludde
Administrator
Registered: 2018-03-09
Posts: 117

Re: After installation, what do I do now?

You need to have a config file from a VPN provider.

You can get one for free here : https://tunsafe.com/vpn

Then you run it like: sudo tunsafe ConfigFile.conf

Offline

Board footer

Powered by FluxBB