TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2019-02-28 09:39:28

donnib
Member
Registered: 2019-02-28
Posts: 1

Tunsafe is using wrong gateway for IPv6

Hi,
I can see that Tunsafe is using the wrong gateway for IPv6 so for example if the Interface Address is 2b00:7550:310:2::2/64 then Tunsafe will wrongly use 2b00:7550:310::1 when it should instead have used 2b00:7550:310:2::1. This means the route will be made wrong and i can't access any IPv6 from the tunnel.

Also the route is made i believe wrongly. in Windows it says :

::/1                     2b00:7550:310::1

but i believe it should be :

::/0                     2b00:7550:310:2::1

Notice the ::/0 and not ::/1.

/donnib

Last edited by donnib (2019-02-28 11:03:29)

Offline

#2 2019-03-01 13:24:20

Hitchhiker
Member
From: The Netherlands
Registered: 2018-12-11
Posts: 35

Re: Tunsafe is using wrong gateway for IPv6

Try switching to DNS Watch servers: https://dns.watch/index

Before you try connecting run ipconfig /flushdns from an elevated command prompt to remove previous connection data.

Offline

Board footer

Powered by FluxBB