TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2019-01-29 18:26:34

n8chavez
Member
Registered: 2018-08-13
Posts: 8

TunSafe-1.5-rc2 and Plex

I'm having an issue with TunSafe-1.5-rc2 and plex.  I cannot connect Plex, either remotely or via wifi, in TunSafe is running and I cannot figure out why.  I can connect to it fine if I use any OpenVPN-base software from the same service that I use wireguard through.  It doesn't seem to matter if I enable or disable the tunsafe killswitch(es), route or firewall.  I still cannot connect to plex.

Any ideas?

Offline

#2 2019-01-29 19:49:29

francisuk1989
Member
From: West Europe
Registered: 2018-07-05
Posts: 8
Website

Re: TunSafe-1.5-rc2 and Plex

Plex wont work with Tunsafe servers as they dont allow any incoming port ranging 32400-32401

Offline

#3 2019-01-29 22:09:30

n8chavez
Member
Registered: 2018-08-13
Posts: 8

Re: TunSafe-1.5-rc2 and Plex

francisuk1989 wrote:

Plex wont work with Tunsafe servers as they dont allow any incoming port ranging 32400-32401


I'm not using Tunsafe servers though.  I'm using Mullvad.  And I've configured plex to use ports that are forwarded through Mullvad.

Offline

Board footer

Powered by FluxBB