TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2020-03-15 17:30:18

Mike Chester W
Member
Registered: 2020-03-15
Posts: 1

Run with Windows Command Line

Hello,

    I don't understand what <interface> means in the start command in TunSafe.exe. Seems this is the only way to run TunSafe in windows command line. Could anyone give an example to run TunSafe in this way?

Last edited by Mike Chester W (2020-03-15 17:31:47)

Offline

Board footer

Powered by FluxBB