TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2018-06-14 22:43:39

forumuser
Member
Registered: 2018-06-14
Posts: 25

Request - Calling TunSafe.exe with command line parameters

Hi Ludde,

it would be nice if we could call TunSafe.exe with command line parameters

Something like:
TunSafe.exe "<name of a .conf file>" /tray

<name of a .conf file>: Full path or if used without path it looks for it in the "Config" folder automatically
/tray (or /min or ...): Put TunSafe in the system tray area only and if possible: Don't show it's main window while doing this

This would allow an easy way of autostarting + let it autoconnect via the task planner (with highest privileges)...

Regards,
forumuser

Offline

#2 2018-06-18 20:07:36

ludde
Administrator
Registered: 2018-03-09
Posts: 128

Re: Request - Calling TunSafe.exe with command line parameters

Good idea, will implement in the next version.

Offline

Board footer

Powered by FluxBB