TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2018-04-24 18:33:06

winlinos
Member
Registered: 2018-04-24
Posts: 1

Doesn't work with Mullavad

Mullavad vpn has a wireguard config generator and it doesn't work.

You can create an account there and use 3 hour trial and check it yourself.

Thank you

Offline

#2 2018-04-25 04:13:08

WireGuardDriver
Member
Registered: 2018-04-25
Posts: 2

Re: Doesn't work with Mullavad

To use TunSafe with Mullvad WireGuard, take note of the following points; 
-it does not accept /32 or /31 so you would have to use a different subnet.
-you can try connecting to se2 server, and set it to use a /10 subnet instead of a /32, it will then assume 10.64.0.1 as the gateway, and it should work.

Keep in mind Mullvad doesn't  recommend using Tunsafe since they don't consider it to be stable yet.

Try this changes & report back...

Last edited by WireGuardDriver (2018-04-25 04:14:28)

Offline

#3 2018-04-29 20:22:51

ludde
Administrator
Registered: 2018-03-09
Posts: 128

Re: Doesn't work with Mullavad

Version 1.2 is now available. If a /32 address is specified it changes it to /24 and prints a warning.

Offline

#4 2018-04-30 03:34:56

WireGuardDriver
Member
Registered: 2018-04-25
Posts: 2

Re: Doesn't work with Mullavad

Thanks for Version 1.2, it now works fine with Mullvad.  smile

Offline

#5 2018-04-30 23:46:25

logcabin
Member
Registered: 2018-04-30
Posts: 27

Re: Doesn't work with Mullavad

Working fine with both Mullvad and Azire. I'm wondering if it would be faster as a kernel driver.

Offline

Board footer

Powered by FluxBB