TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2020-02-02 14:01:48

Registered: 2020-02-02
Posts: 1

Parse error after install

Hi have installed TunSafe and all went well until I tried to run it.  I found help re the location of the .conf file but now all I can get is:

Error parsing interface and TunSafe wont run.

Anyone able to help?

Am relatively new to Linux and running latest version (tricia) of linux mint


Board footer

Powered by FluxBB