TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2019-11-09 10:35:03

Registered: 2019-11-09
Posts: 1

Connection failed to home server

HI all

I'm running a wireguard server at home on a raspberry pi, have been using it with the official wireguard client so far and it worked with no issues. I'd now like to use tunsafe for the added functionality to auto start the tunnel when not home etc, but every time I try to start the tunnel, it just initializes and then shows "failed" immediately. I created a new peer on the raspberry just to be sure, but even on the new one it fails. Is there a log anywhere to check what's going wrong? Or has anyone faced similar issues? If I connect to the AMS public server it works.

Thank you


Board footer

Powered by FluxBB