TunSafe Forum

Welcome to the TunSafe Community Forum. This is open for discussions related to TunSafe and the WireGuard protocol.

You are not logged in.

#1 2019-03-23 16:30:02

yessr
Member
Registered: 2019-03-23
Posts: 1

Is there a way for TunSafe not to access the gateway?

I am from China, I used TunSafe to break through the blockade.

I found it when linking,It will access the gateway.
But in my school network environment, the gateway is provided by the school.
This gateway may have discarded TunSafe's packets, causing TunSafe to fail to connect.

When I manually set the gateway address to 0.0.0.0, TunSafe can connect.
But doing so makes me unable to access the resources inside the school.

So I am here for help, is there a way for TunSafe not to access the gateway?
Thank you in advance for your help.








Attach a connection log

[23:32:11] TAP Driver Version 9.21
[23:32:11] Blocking standard DNS on all adapters
[23:32:11] Added Route 0.0.0.0/1  =>  10.0.0.1
[23:32:11] Added Route 128.0.0.0/1  =>  10.0.0.1
[23:32:11] Added Route 195.123.221.136/32  =>  172.21.77.254
[23:32:11] Sending handshake...
[23:32:16] Retrying handshake, attempt 2...


[23:33:21] TAP Driver Version 9.21
[23:33:21] Blocking standard DNS on all adapters
[23:33:21] Added Route 0.0.0.0/1  =>  10.0.0.1
[23:33:21] Added Route 128.0.0.0/1  =>  10.0.0.1
[23:33:21] Added Route 195.123.221.136/32  =>  0.0.0.0
[23:33:21] Sending handshake...
[23:33:22] Connection established. IP 10.0.0.3

Last edited by yessr (2019-03-23 16:40:00)

Offline

Board footer

Powered by FluxBB